基于抛光基材的热蒸镀铜箔生长高平整单层石墨烯薄膜

在石墨烯的化学气相沉积工艺中,铜箔是决定石墨烯薄膜质量的重要因素。传统铜箔由于制备工艺的限制,存在大量的缺陷,导致石墨烯薄膜的成核密度较高。本工作选用抛光铝板、抛光不锈钢板、微晶玻璃和SiO₂/Si作为基材,用热蒸镀法制备了不同粗糙度的铜箔,并详细讨论了以该系列铜箔生长高平整度石墨烯薄膜的条件及铜箔对石墨烯薄膜品质的影响。实验结果表明,铜箔以(111)取向为主,与基材分离后,表面具有纳米级平整度。在生长石墨烯后,从SiO₂/Si剥离的铜箔成核密度是4种基材中最小的。同时,从SiO₂/Si剥离的铜箔晶体结构变化最不明显,具有良好的结晶性,表面几乎不存在铜晶界缺陷。当压强为3 000 Pa,氢气和甲烷流速分别为300 mL/min和0.5 mL/min时,可以获得约1 mm横向尺寸的石墨烯单晶晶畴。     

压气机悬臂静叶流场非定常数值模拟

以现代高压压气机一排悬臂静叶与一排转叶组成的典型级为研究对象,采用非定常数值模拟方法,分析了非定常与定常数值模拟计算得出的级特性线以及峰值效率点气动参数在展向分布的差异,并对悬臂静叶内部流场结构进行了详细分析,结果表明:当悬臂静叶的轮毂设计间隙为2.5%叶高时,非定常计算的综合喘振裕度比定常大5.85%;在峰值效率点工况下,悬臂静叶总压损失和转子效率的非定常影响范围在10%以内,转叶进口相对气流角沿展向分布的影响在0.5°以内。悬臂静叶根部10%叶高以下区域出现了明显的泄漏流动,3.4%叶高压力系数变化最大,轮毂泄漏流起始于20%弦长附近,发展到70%弦长位置时泄漏损失最大,随后逐渐减弱.     

静止轨道星载差分吸收光谱仪CCD成像系统设计

静止轨道卫星差分吸收光谱仪采用摆扫成像方式对大气进行探测,针对其工作时CCD成像系统信噪比大于1 000、高速探测模式下探测周期小于10min、高分辨率模式下探测周期小于1h的要求,进行CCD成像系统设计.选取CCD47-20作为探测器,设计成像电路实现光谱图像信号的采集和上传.分析了帧叠加和像元合并对时间、空间分辨率的影响.结合帧转移CCD的特点设计了每个位置最后一帧读出时摆镜转动的成像方式,并合理设置了帧叠加数和像元合并数,达到优化成像周期的目的.1s曝光时间条件下,该CCD成像系统的高速、高分辨率模式探测周期分别为515s和3 315s,图像信噪比均大于1 000,污染物观测实验中未出现失帧或重复的现象.该CCD成像系统方案满足静止轨道星载差分吸收光谱仪的探测需求,为静止轨道环境监测仪器设计提供参考.     

Hierarchical Mn3O4 Anchored on 3D Graphene Aerogels via C−O−Mn Linkage with Superior Electrochemical Performance for Flexible Asymmetric Supercapacitor

Flexible asymmetric supercapacitors are more appealing in flexible electronics because of high power density, wide cell voltage, and higher energy density than symmetric supercapacitors in aqueous electrolyte. In virtues of excellent conductivity, rich porous structure and interconnected honeycomb structure, three dimensional graphene aerogels show great potential as electrode in asymmetric supercapacitors. However, graphene aerogels are rarely used in flexible asymmetric supercapacitors because of easily re-stacking of graphene sheets, resulting in low electrochemical activity. Herein, flower-like hierarchical Mn₃O₄ and carbon nanohorns are incorporated into three dimensional graphene aerogels to restrain the stack of graphene sheets, and are applied as the positive and negative electrode for asymmetric supercapacitors devices, respectively. Besides, a strong chemical coupling between Mn₃O₄ and graphene via the C-O-Mn linkage is constructed and can provide a good electron-transport pathway during cycles. Consequently, the asymmetric supercapacitor device shows high rate cycle stability (87.8 % after 5000 cycles) and achieves a high energy density of 17.4 μWh cm⁻² with power density of 14.1 mW cm⁻² (156.7 mW cm⁻³) at 1.4 V.     

Lattice Compression Revealed at the ≈1 nm Scale

Lattice tuning at the ≈1 nm scale is fascinating and challenging; for instance, lattice compression at such a minuscule scale has not been observed. The lattice compression might also bring about some unusual properties, which waits to be verified. Through ligand induction, we herein achieve the lattice compression in a ≈1 nm gold nanocluster for the first time, as detected by the single-crystal X-ray crystallography. In a freshly synthesized Au₅₂(CHT)₂₈ (CHT=S-c−C₆H₁₁) nanocluster, the lattice distance of the (110) facet is found to be compressed from 4.51 to 3.58 Å at the near end. However, the lattice distances of the (111) and (100) facets show no change in different positions. The lattice-compressed nanocluster exhibits superior electrocatalytic activity for the CO₂ reduction reaction (CO₂RR) compared to that exhibited by the same-sized Au₅₂(TBBT)₃₂ (TBBT=4-tert-butyl-benzenethiolate) nanocluster and larger Au nanocrystals without lattice variation, indicating that lattice tuning is an efficient method for tailoring the properties of metal nanoclusters. Further theoretical calculations explain the high CO₂RR performance of the lattice-compressed Au₅₂(CHT)₂₈ and provide a correlation between its structure and catalytic activity.     

最大泡压法测表面张力等温线的数据处理方法比较*

对乙酸、丙酸、正丁酸、2-甲基丁酸、3-甲基丁酸、正戊酸、正己酸、乙醇、丙醇、异丙醇、正丁醇、异丁醇、1,2-丙二醇等13种常用试剂在25 ℃下的表面张力数据拟合方法进行了比较,分析了图解法处理数据及多项式、一阶指数函数、幂函数、Shishkovsky经验公式拟合数据的优缺点。指出Shishkovsky经验公式拟合结果准确,受数据样本量影响小,是理想的表面张力数据拟合方法。     

纸质包装材料中甲醛、乙醛向食品模拟物改性聚苯醚的迁移行为

为了解纸质包装材料中甲醛、乙醛向食品模拟物改性聚苯醚( Tenax)中的迁移行为,建立了一步提取衍生化、超高效液相色谱测定纸质包装材料和Tenax中的甲醛和乙醛的方法。本方法在甲醛和乙醛的测定范围内,线性相关系数R2>0.9999,甲醛检出限为0.03 mg/m2,乙醛检出限为0.04 mg/m2,测定纸样和Tenax的加标回收率为90.1%~108.6%。采用本方法研究不同温度和时间下两种纸质包装材料中甲醛、乙醛向Tenax中的迁移规律。研究表明,甲醛、乙醛迁移行为随时间变化趋势大致相同,均呈现迁移率随迁移时间延长先迅速增大,后又减小达到一个常数;甲醛和乙醛迁移率受温度的影响不同,达到平衡后,甲醛在30℃下迁移率最高,乙醛在70℃和50℃下迁移率高;甲醛和乙醛向Tenax中的迁移率差异较大,达到平衡后,乙醛的迁移率远高于甲醛。     

紫外荧光光谱法测定焦炉气中的痕量总硫

采用紫外荧光光谱法测定焦炉气制取液化天然气的原料气中痕量总硫,考察了样品引入速率、进样量、气体流量、燃烧温度、取样方式和进样方式等条件对分析结果的影响。总硫检出限为15μL·m-3,测定结果与气相色谱法和微库仑法的结果相吻合,测定值的相对标准偏差(n=7)小于10%。     

Unusual Ultra‐Hydrophilic,Porous Carbon Cuboids for Atmospheric‐Water Capture

There is significant interest in high‐performance materials that can directly and efficiently capture water vapor, particularly from air. Herein, we report a class of novel porous carbon cuboids with unusual ultra‐hydrophilic properties, over which the synergistic effects between surface heterogeneity and micropore architecture is maximized, leading to the best atmospheric water‐capture performance among porous carbons to date, with a water capacity of up to 9.82 mmol g^?1 at P/P₀=0.2 and 25 °C (20 % relative humidity or 6000 ppm). Benefiting from properties, such as defined morphology, narrow pore size distribution, and high heterogeneity, this series of functional carbons may serve as model materials for fundamental research on carbon chemistry and the advance of new types of materials for water‐vapor capture as well as other applications requiring combined highly hydrophilic surface chemistry, developed hierarchical porosity, and excellent stability.     

青海省黑泉水库混凝土面板坝的工程地质问题与工程处理措施

黑泉混凝土面板坝高 1 2 3.5 0m ,位居中国已建成的混凝土面板坝第四。坝址地形破碎 ,构造发育 ,工程地质条件复杂 ,河床第四纪砂卵砾石层存在不利于坝体稳定和变形的夹层 ,大坝设计采取了一些独具特色的结构措施 ,较好地适应了特殊的地质条件。本文重点分析了大坝的工程地质条件及相应的工程处理措施。